Shop

Pair of 1.2V 3000mAh rechargeable NiMH AA batteries for remotes, toys, cameras and electronics.

Quick View

AMC1301

AMC1301 precision isolated amplifier for accurate current and voltage measurement across a galvanic isolation barrier.

Add to cart

Quick View

3S 10A BMS Protection Module

3S 10A BMS protection board for 3-cell Li-ion or LiPo packs, with overcharge, over-discharge and short protection.

Quick View

Oraimo type C USB cable for ESP

Oraimo USB Type-C cable for uploading code to and powering USB-C ESP32/ESP8266 boards, plus everyday charging.

Add to cart

Quick View

3*55mm Off-road Wheel Rubber Tire

KSh 420.00

55 mm off-road rubber tyre with knobby tread and plastic rim (3 mm hole), for RC cars and robots on rough terrain.

Add to cart

Quick View

GSM TD-SCDMA 3G/4G Antenna 1.5m SMA female

KSh 420.00

3G/4G GSM disk antenna with cable and SMA female connector, to boost cellular signal on GSM modules and routers.

Quick View

GSM TD-SCDMA sucker Antenna – 1.5m SMA male

KSh 420.00

3G/4G GSM sucker antenna with cable and SMA male connector, to improve cellular reception on GSM modules and routers.

Add to cart

Quick View

DHT11 temperature & humidity sensor

Low-cost DHT11 digital sensor that measures temperature (0-50°C) and humidity (20-80% RH) on a single data pin. Works with Arduino and ESP32 at 3.3-5V.

Add to cart

This is an Image of a motor driver board

Quick View

L298 Dual H-Bridge Motor Driver Board

Rated 5.00 out of 5

L298 dual H-bridge motor driver board for independent speed and direction control of two DC motors (up to 2A each) or one stepper motor.

Add to cart

Quick View

9V 1A power Supply

Regulated 9V 1A DC power supply adapter for Arduino boards, routers and small electronic devices.

Add to cart

Quick View

3A 1203BK PWM DC Motor Speed Controller Regulator

1203BK 3A PWM speed controller with an adjustment knob, for smooth speed control of small DC motors, fans and pumps.

Add to cart

Quick View

Arduino UNO R3 V5.0 Expansion Board

Uno R3 V5.0 sensor shield with signal-VCC-GND header rows, making sensor and servo wiring quick and tidy.

Add to cart

Quick View

TPL5010 Nano-Power System Watchdog IC

TPL5010 ultra-low-power timer and watchdog that wakes a microcontroller at set intervals to save battery.

Quick View

LM2596 DC Buck Step Down Power Converter Module with Display

KSh 480.00

LM2596 adjustable step-down converter with a built-in display, so you can set and read the output voltage easily.

Add to cart

Quick View

21 x 30 cm Double Sided Copper clad

KSh 480.00

21 x 30 cm double-sided copper clad board for etching or milling two-layer PCBs and custom circuit prototypes.

Quick View

ESP8266 ESP-07 Remote Serial Port WIFI Module

KSh 480.00

ESP8266 ESP-07 serial (UART) Wi-Fi module with external antenna connector for better range.

Add to cart

Quick View

MG90S Servo Motor (metallic gear)

KSh 490.00

MG90S micro servo with metal gears, a stronger, longer-lasting upgrade to the SG90 for robot arms, RC models and pan-tilt mounts.

Add to cart

Quick View

CP2102 UART Serial Interface Module USB to TTL

Rated 5.00 out of 5

CP2102 USB to TTL UART adapter for programming and debugging ESP8266, ESP32 and Arduino boards from a PC.

Add to cart

Quick View

ACS712ELC 20A Current Sensor

ACS712ELC 20A Current SensorRead More

– Internal conductor resistance: 1.2 mΩ – Device bandwidth set via the new FILTER pin …

Add to cart

Quick View

5 Channel TCRT5000 IR Infrared Line Tracking Sensor

5-channel TCRT5000 infrared line tracking sensor that detects black lines on light surfaces, the core sensor for line-following robots.

Add to cart

Quick View

ADS1115 Analog-to-Digital Converter (ADC)

ADS1115 16-bit, 4-channel I2C ADC for precise analog sensor readings on Arduino, ESP32 and Raspberry Pi.

Add to cart

Quick View

USB 2.0 to TTL RS485 Serial Converter Module

USB 2.0 to RS485 converter for connecting a PC to RS485 and Modbus industrial devices.

Add to cart

Quick View

FTDI 232RL USB to TTL Serial Adapter Module

FTDI FT232RL USB to TTL serial adapter for programming Arduino Pro Mini and ESP boards and serial debugging.

Add to cart

Quick View

3.7 v Li-ion smart battery charger

Smart charger for 3.7V Li-ion cells such as 18650s, with automatic charge control for safe, full charging.

Add to cart

Quick View

Mini submersible water pump 3/5V

Low-power 3-5V mini submersible pump for aquariums, hydroponics, small fountains and automatic plant watering.

Add to cart

Quick View

MAX30102 Heart Rate/ Oxygen Sensor (pulse)

MAX30102 optical heart rate and SpO2 sensor module with I2C output for wearable and fitness projects. For education and prototyping, not medical use.

Add to cart

Quick View

DC Power Shield V1.1.0 For WEMOS D1 Mini

DC Power Shield V1.1.0 that stacks on a Wemos D1 Mini and powers it from a DC barrel-jack supply.

Add to cart

Quick View

4 Channel Relay Module with Optocoupler

4-channel optocoupler-isolated relay module for switching four lights or appliances from Arduino or Raspberry Pi.

Add to cart

Quick View

10 Kg + HX711 Load Cell – Weight sensor

10kg strain-gauge load cell with HX711 24-bit amplifier for building digital scales and load monitoring systems with Arduino and ESP32.

Add to cart

Quick View

16*2 LCD with I2C

16×2 character LCD fitted with an I2C backpack, so it needs only two data pins on Arduino or ESP32.

Add to cart

Quick View

50A 75mV Shunt resistor

50A / 75mV precision DC current shunt with brass terminals, for panel ammeters and solar or battery current monitoring.

Add to cart

Quick View

MQ2 Gas Sensor

MQ2 gas sensor module that detects LPG, other combustible gases and smoke, for gas leak and smoke alarms with Arduino.

Add to cart

Quick View

MPU6050 Accelerometer + Gyro